RouterBOOT

				
					# d - boot delay:

Select boot delay:
   1 - 1s
 * 2 - 2s
   3 - 3s
   4 - 4s
   5 - 5s
   6 - 6s
   7 - 7s
   8 - 8s
   9 - 9s

# k - boot key:

Select key which will enter setup on boot:
 * 1 - any key
   2 - <Delete> key only

# s - serial console:

Select baud rate for serial console:
 * 1 - 115200
   2 - 57600
   3 - 38400
   4 - 19200
   5 - 9600
   6 - 4800
   7 - 2400
   8 - 1200
   9 - off

# n - silent boot:

Silent boot:
   0 - off
 * 1 - on

# o - boot device:

Select boot device:
   e - boot over Ethernet
 * n - boot from NAND, if fail then Ethernet
   1 - boot Ethernet once, then NAND
   o - boot from NAND only
   b - boot chosen device
   f - boot Flash Configure Mode
   3 - boot Flash Configure Mode once, then NAND


# f - cpu frequency:

Select CPU frequency:
   a -  200MHz
   b -  400MHz
   c -  600MHz
   d -  800MHz
   e - 1000MHz
 * f - 1200MHz

# r - reset booter configuration:

# e - format nand:

Do you realy want to format your storage device?
that would result in losing all your data
type "yes" to confirm: 

# w - repartition nand:

Select parititon count:
   1 - partition
 * 2 - partitions
   3 - partitions
   4 - partitions

# y - active partition:

Select active partiton:
 * 0 - partition
   1 - partition

# g - upgrade firmware:

Upgrade firmware options:
   e - upgrade firmware over ethernet
   s - upgrade firmware over serial port

# i - board info:

Board Info:

        Board type: CCR1009-8G-1S-1S+
     Serial number: 48FF01DDE6FD
  Firmware version: 3.19
     CPU frequency: 1200 MHz
       Memory size: 2048 MiB
         NAND size: 128 MiB
        Build time: 2014-09-23 15:02:34
  eth1 MAC address: 00:0C:42:00:BE:4A
  eth2 MAC address: 00:0C:42:00:BE:4B
  eth3 MAC address: 00:0C:42:00:BE:4C
  eth4 MAC address: 00:0C:42:00:BE:4D
  eth5 MAC address: 00:0C:42:00:BE:4E
  eth6 MAC address: 00:0C:42:00:BE:4F
  eth7 MAC address: 00:0C:42:00:BE:50
  eth8 MAC address: 00:0C:42:00:BE:51
  eth9 MAC address: 00:0C:42:00:BE:52
 eth10 MAC address: 00:0C:42:00:BE:53

# p - boot protocol:

Choose which boot protocol to use:
 * 1 - bootp protocol
   2 - dhcp protocol

# b - booter options:

Select which booter you want to load:
 * 1 - load regular booter
   2 - force backup-booter loading

#t - do memory testing:

launches built in memory test!

# x - exit setup:

Exit bios configuration menu and continues with system startup.